tag:blogger.com,1999:blog-1842136564899097734.post5871704385222953716..comments2023-12-15T02:04:08.213-08:00Comments on meat: Suicidal sheep and grass fed animalsBruce Kinghttp://www.blogger.com/profile/10995706761794063165noreply@blogger.comBlogger9125tag:blogger.com,1999:blog-1842136564899097734.post-50026110645932653932012-05-30T10:36:32.065-07:002012-05-30T10:36:32.065-07:00I only use them for poultry including ducks and ge...I only use them for poultry including ducks and geese. I have had some birds get tangled but only when I had the power off. I keep a few step in posts and use them at sag points. I also have the premier poultry plus fencing and don't usually use anything extra with that fence. After I set the fence up I go around and stretch the space out a bit to prevent sagging. Even on uneven ground I don't generally need the extra step in posts with the plus fencing. <br /><br />I am not at all happy with the Kencove fencing. It has nibs on the top that snag things and and cause more tangling. The verticals are solid rather than woven but actually sag more not less. I think most of the geese tangled up in fencing has happened with the Kencove fencing.Cathyhttps://www.blogger.com/profile/14786327481214450958noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-48173511557055361342012-05-26T06:25:59.055-07:002012-05-26T06:25:59.055-07:00I find it a good idea to clip the bottom hot wires...I find it a good idea to clip the bottom hot wires at the ends, stretch the fence very tight, add extra vertical posts in any sags (we're on uneven hillside), pin the bottom for the same reason and use a very strong fence energizer to keep the animals from sticking their heads into the fencing. Sometimes we've even run an interior offset wire for recalcitrants but I cull those quickly as possible and that works even better.<br /><br />The one issue with the high fence charger power is the netting may burn out at places where wires are sparking. This is more of a problem with older netting which has breaks in the wires. Clickity, clickity.Walter Jeffrieshttps://www.blogger.com/profile/12720110642967540506noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-88480241830231955452012-05-26T00:44:41.825-07:002012-05-26T00:44:41.825-07:00good times on using additional posts between the a...good times on using additional posts between the attached ones. I'm going to try just tying up the middle of each fence with some bailing twine. I'm looking for something that I can just roll up with the fencing so that I don't have to put in more posts.Bruce Kinghttps://www.blogger.com/profile/10995706761794063165noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-44092327614825775552012-05-26T00:42:36.527-07:002012-05-26T00:42:36.527-07:00Lee, having just received this fencing from premie...Lee, having just received this fencing from premier, I'm assuming that they included whatever documentation they thought was appropriate. I followed their instructions as provided, and just to make sure I didn't miss anything, I watched their instructional video at<br /><br />http://www.premier1supplies.com/videos/player.php?video=installing_electronet&size=large<br /><br />Nowhere in the supplied literature or the video do they say that the grass should be mowed below 4 inches. They do show an ATV and say "for longer grass, run the bike back and forth to make a path". In my case, with this poultry net, the grass would have to be pretty darned short to not contact the lower strands of conducting wire. <br /><br />For my installations I think I'm going to have to mow a fenceline each time I move the fence, as I usually maintain the pasture grass at longer than 6". It's a lot less handy than I'd like it to be. <br /><br />My main gripe is that they should be a little clearer about vegetation touching the net. Wet grass makes it ineffective without a hell of a charger. The charger that I'm using is rated more powerful than their recommended charger.Bruce Kinghttps://www.blogger.com/profile/10995706761794063165noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-12503611112550524432012-05-25T23:44:21.912-07:002012-05-25T23:44:21.912-07:00It's too bad you lost a lamb. The people I kn...It's too bad you lost a lamb. The people I know who raise sheep always have tales of bizarre livestock death.<br /><br />We have been using the Premier PermaNet for several years to control chickens, both electrified and not and are very happy with it. The Premier instruction page about their netting is very specific that the grass needs to be mowed to below 4 inches. Also, they recommend checking that the charge is above 3000V before you trust animals too it, as below that the shock will be too low for it to be an effective pain barrier. If you can't mow or spray, netting might not be a product that is well suited to you.<br /><br />Throwback might not mow down the grass, but I don't see how you could keep a charge on those closely spaced low wires in foot deep wet grass without one monster of a fence charger. Preventing sags in the fence can be a challenge. I've helped someone move PoultryNet before, and we are much happier with the heavier PermaNet posts. (Especially if you don't move the fence very often.)Lee Johnsonhttps://www.blogger.com/profile/13736680452703464160noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-48207703693159486412012-05-25T19:59:07.638-07:002012-05-25T19:59:07.638-07:00Sorry to hear about your lambs. I hope the second ...Sorry to hear about your lambs. I hope the second one recovers.becky3086https://www.blogger.com/profile/01026872543168452124noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-87386958352698178782012-05-25T17:16:41.199-07:002012-05-25T17:16:41.199-07:00We must have a shining cloud over us, because we u...We must have a shining cloud over us, because we use lots of this fence and never have had problems like this and others I have read about. Ours is hot enough to keep everyone in, with a low-impedance Pel battery type charger. Although we have two ground rods and run an electrifying wire to the actual net fence. We don't waste time mowing, tramping or making the fence sag-datskin free, if it is properly charged it works great. We do prefer the poultry netting to the Electronet, our original Electronet was shot in 5 years, but we have been using our Premier Poultry Netting since '99 and it is all still good except where we have caught it on a vehicle or something stupid like that. One tip I got from Andy lee of Chicken Tractor fame was to NOT connect the clips and give the electricity an outlet instead of a continuous circle or square. <br /><br />That sucks losing an animal like that, they represent a lot of lost time, effort and money.Throwback at Trapper Creekhttps://www.blogger.com/profile/12418370592659531735noreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-68509569319179435462012-05-25T11:06:28.027-07:002012-05-25T11:06:28.027-07:00I have both types from Premier, and the poultry ne...I have both types from Premier, and the poultry netting is definitely harder to get taut. But there are some tricks- as I walk, I slide the posts along the wire and pull each section tight when I seat the post. The lines have to be straight, and then I use thicker step-in posts at the corners to put more tension on the line. And the grass needs to be squished down good. If it's lumpy, as they graze the fence line, their head can slide under the bottom, and before they know it, they've slid under it. <br /><br />It's good to get a tester and check it every day, to catch mistakes like accidentally looping a conductive wire under the metal stake, which can be hard to spot. Or sometimes I forget to clip the sections together! I've lost a couple of sheep to it as well, though, it's a risk-benefit trade-off for sure.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-1842136564899097734.post-608222042202955142012-05-25T07:28:43.318-07:002012-05-25T07:28:43.318-07:00We use the same fencing for our chickens. Best way...We use the same fencing for our chickens. Best way we've found to keep it all upright and straight is to put a fiberglass pole post between each of the fence posts. We just get the little pinch clips that slip over the top of the post and then hook the top line of the fencing over them. Takes a little extra work, but fixes the problem. Just make sure that if you buy the posts, you get the little black drive cap with the bundle. Those posts splinter pretty bad when hammered in, unless you have that cap to protect the end.Raehttps://www.blogger.com/profile/02769150016495656772noreply@blogger.com